Making some progress on the rear four-link

Here are some mock-ups of the rear four-link brackets and links. The truss over the 14-bolt was made from a 4″ wide x 1/2″ thick piece of plate steel. I put a lot of heat into it to get the bends correct. I torched and ground it at both ends to fit the tubes. This made a nice mount for the upper links as well as attach the new diff cover and reinforcement. The links are 2″ DOM 1/4″ wall tubing.

This entry was posted in Jeep. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *